Bread board power wires
Posted by Gary | Uncategorized
This may seem a little trivial for a post, but I did it so I thought I would share.
I took a regulated 12 volt power supply and added a regulated 5 volt and adjustable supplies to it. I used some old speaker terminals I had around for the facing connections on the power supply. I wanted to have some wires that I didn’t have to screw down so I got some banana clips and male header pins to make my own wires that will work with the bread board and the power supply easily.
I got the banana clips and male headers from Tayda Electronics.
-
- Regulated Power Supply
-
- Cutting Tools
-
- Required Hardware
-
- Wires
-
- Breadboard
-
- Soldering Iron
-
- Solder
-
- Solder Paste
-
- Helping hand
-
- Header end of the wire
-
- Banana Clip end
-
- Banana Clip
-
- Push opposite directions
-
- Ferril of Banana Clip
-
- Solder on the Iron tip
-
- Wire in the clip ferril
-
- Wire soldered to the ferril
-
- Shrink tube around the ferril and soldered wire
-
- Shrink the shrink tube
-
- get it all
-
- Put it all together
-
- Shrink tube for the header end
-
- Header with solder paste on it
-
- header soldered to wire
-
- shrink tube on the header end
-
- Finished wire
-
- New wires in use
-
- Different angle
